Alta mxr 2018 not charging. - Solved

[Jared]

So when you send the ID 0x1806e5f4 0b b8 00 64 00 e8 from the laptop to the charger specifying charge cutoff of 325vdc, but the charger’s relay is manually closed, will it actually terminate the charging automatically or do you have to monitor progress and manually stop the charger?

 

[Jared]

It looks like you have jumper wires on the DCCP board so that the charger can “see” the battery, but doesn’t this also mean that the DCCP cannot disconnect the battery at the end of charging. Also, since the bike is in drive mode to close the contactors/relays in the battery lid, and you are not operating the bike, how do you keep the bike from timing out and turning off/disconnecting the battery before it is charged?

 

[sergeynik]

This is a temporary test solution.
The other day I will make my block on stm32f105

 

[sergeynik]

Get to know my DCCP module

 

[TCMB371]

FYI all of the canids are displayed in MultiTool.

 

[sergeynik]

I got them from there. Needs values for the full info

 

[flask38]

Wow I hope my used 2018 EX I just purchased doesn't have any issues...I hope you find a new circuit board. That was amazing engineering you are very technical!